M-LVDS receivers detect conditions including open-circuit, short-circuit, line disconnect and disabled drivers. This failsafe approach also provides the desired benefit of working over the full ...

But LVDS interface load impedance has been specified as 100 ohms, one 100-ohm termination resistor must be add at the receiver side. If a long link is used for the interface, such as a PCB microstrip ...

Figure 1 shows the rudiments of this one-shot, in which A1 represents the LVDS receiver. A negative input pulse causes U1's output to fall, turning off Q1, and allowing the voltage at its emitter ...

LVDS signal lines are differentially terminated at the receiver with a 100-Ω resistor across the line. A 350-mV signal is generated across this 100-Ω resistor by a 3.5-mA current source within ...

This new reference design, which deserializes bit streams from TI's ADS527x analog-to-digital converter (ADC) family, and accompanying application note provide a quick and easy solution for designers ...

The dual link LVDS transmitter (FPD-TX) and the LVDS receiver link (FPD-RX) are mixed-signal, hard macros that provide high levels of functionality and flexibility. These IP blocks are silicon-proven ...